Skip to content

jweoblog

3D printing and assorted geekery

Projects
About

P1030360

Published November 4, 2015 in Z-probe V2: Autoleveling

The bad old days. Tape around the side of the bed ineffectively holding the glass in place

Leave a Reply Cancel reply

Your email address will not be published. Required fields are marked *

Comment

Name *

Email *

Website

Decode Theme by Macho Themes

Search for:

Recent Posts

Fan makes overhang worse!
Z-probe V3: Now With Wings
Bed sparking protection and logging
Multi Setting Calibration Prints
3D Printer Safety Cutoff

Recent Comments

Cartesian Theatrics on Creating Shells with OpenSCAD
Solomon Ucko on Creating Shells with OpenSCAD
Sarah on Creating Shells with OpenSCAD
Clair on Measuring a 3D Printer Bed’s Flatness
bitcoin revolution platform on About

Archives

February 2018
October 2017
August 2016
July 2016
June 2016
May 2016
February 2016
January 2016
November 2015
October 2015
September 2015
July 2015
June 2015
January 2015
December 2014
November 2014
October 2014
August 2014
July 2014
June 2014
May 2014
April 2014
February 2014
January 2014
June 2013

Categories

3D Designs
3D Printing Software
Analogue Electronics
Arduino
Cameo
Case
Costume
Electronics
Great Printing Fails of Our Time
Hackathon
Host Software
Huxley
Javascript
Networking
OpenSCAD
Printer Accessories
Printer Control
Programming
Python
Raspberry Pi
Slicing Software
Touch Board
Uncategorized
Uno

Meta

Register
Log in
Entries RSS
Comments RSS
WordPress.org